Spriya Anet A8 Two-Piece

thingiverse

This is a modification of lokster's Spriya Fan Duct modified to be printed in two separate pieces. The main reason for this design is to avoid printing internal supports. The particular filament that I used to print was very stubborn when printing supports that do not originate on the bed. Technically, this should be usable without removal of any printed support. This may seem like a rather strange way to solve the problem of internal supports, but after struggling for quite a while I'm providing this so that if anyone else faces the same problem they'll have this option open without needing too much extra work. Most of the printing suggestions for the original Spriya hold true for printing this except that Spriya_Two_Piece_Back.stl should be printed upright. This is based off of the thick walled Spriya stl, so that is provided in case anyone would like to modify this design further using OpenSCAD.