SSD 2.5 to 3.5 Full adjusted for OEM

thingiverse

I really liked the original, used it quite a few times, but since I work on a lot of machines I found that the screw holes rarely lined up for more than 1, w/ an ssd that was fine, but not ideal. The sata ports were also closer to the center, which was a problem when upgrading an OEM computer. I moved the SSD screw holes farther to the correct side and expanded the model to line up with all 3 HDD holes, with the spare off center at the same distance for inverted positioning. Then I just removed triangles to minimize waste and decrease print time. Edit: Made a 2nd one from scratch that far more closely positions the ports to an OEM spacing. It's difficult to impossible to do it without solely relying on the side screws, so I did give a 1mm gap underneath to give some support for bottom mounted screws. If I run into a situation where I need 100% flush, I'll make another one.