SSD mount for PCIE risers

thingiverse

I designed this to allow installing extra video cards inside a Thermaltake V150 microatx case but it will work with other cases. This mount screws onto standard 2.5" sata mount spots and has screw holes to mount a GPU riser card. This is best suited to RTX 3060ti's or smaller cards, i could not fit a RTX 3070 on this mount as it was too tall for my setup. Two different versions of the mount are included, one is for a single PCIE GPU riser, and the other allows two PCIE GPU Risers. What you will need: You will need to source M3x7mm screws for the PCIE riser You will need to re-use the screws and rubber feet (optional) supplied with the case. You will need to print out your mount of choice Printing: I printed using PLA I printed flat side down with no supports, no raft, and no brim/wall. I used an infill of 15% Usage: To make installation easier, use one of the HDD screws and pre-screw it half0way into the mounting holes. It helps pre-thread them and makes install easier. Screw your PCiE riser to the mount using M3 screws Install rubber feet in the upper 6 SSD mounting holes (if there is none there already) Use 6 HDD screws to attach the mount to the case. Run your cables and plug in your cards :)