Stackable Container

prusaprinters

<p>I love the Stackable Containers from Dennisbun, so kudos to him for working out those dove tail interfaces!</p> <p>I found it difficult to get small parts back out of the original bins so slopped the front face.</p> <h3>Print Settings</h3> <p>Set extrusion width to 0.65 mm</p> <p>Layer height 0.2 mm (might want to try higher height)</p> <p>Vase mode</p> <p>Low wall speed</p> <p>Bottom layers 3 (at least)</p> <p>Top layers 0</p> <p>The above settings were copied directly from Dennisbun's original Thing.</p> Category: Organization