Stackable Miniature system

thingiverse

This is a shelf system to store your miniatures. There is a shelf (or tray) with pockets for the most popular round base sizes, 25mm, 28mm, 32mm, 40mm. Also there is a self that has no pockets to store models with odd shaped bases. The set comes complete with two types of tops. One is mostly flat with a slight bevel and the other has a rim on it. You can print these without supports. If supports are enabled in your slicer, there will be a small plug form on the bottom where the interlocking posts fit in. Each Shelf / tray will hold mini with up to 70mm height space. That should handle most of the 25-32mm, the 40mm gets a little iffy depending on what you have. 25 - 32mm shelves have 16 pocket positions, the 40 has 9 total positions. The top pieces have two versions. One is flat, and the other has the rim around it so it could be a top shelf for display of your really big and cool parts. I usually get the units I need printed then glue super glue them together into one large piece. There is a rim around the shelf to help prevent the mini's from falling out if the shelf is jostled. This is a complete set of shelves and this version 3 is compatible with my older style for those of you who downloaded that version. The posts on this version are stronger and less prone to bending and breaking. I did put the size in the middle of each one because they look close to each other and I didn't want to forget or mix up the 28's and 25's. You might have to print the 28 to hold some 25's with lots of base dressing. There is 0.7mm diametrical clearance on the base diameters. Sometimes that too small.