Stand for cheap blow-torch from Alliexpress.

cults3d

This is a stand for following blow-torch from alliexpress: https://www.aliexpress.com/item/1005002218122783.html You need to disassemble the the blow torch, unscrew the gas tank adapter and screw it on this stand using the original screws. The propane butane gas supply should be attached using standard pressure resistant hose with inner diameter 8mm and outer diameter 15mm. FreeCAD model attached in case you need to modify the dimensions (see the "Sizes" spreadsheet) Update 2021-08-16: This stand has a serious flaw, which makes it a little bit dangerous. The problem is that the original blow-torch was designed to be put directly on the gas tank, so the expanding gas was in fact cooling the inlet pipe so the plastic parts at the base didn't melted even if you used the blow-torch for rather long. If you however use this stand, that gas has to be attached using rubber hose, so the expanding gas is in fact cooling the hose and the blow torch inlet will get rather hot after a while, which causes that the seal between the stand and the blow-torch gets soft/slightly melted after a while, which causes the gas to start leaking. The gas will continue to accumulate around the base and once it reaches the hot blow-torch it explodes and ignites surrounding flammable objects. (been there, seen that ;-) So use common sense before you print/start using this. btw. as I don't see any reasonable way how to fix the above flaw, I'm publishing this thing as it is, so that others may remix/fix it.