Stand for Elektron Analog Heat, Digitakt, Digitone

thingiverse

Fits Digitone, Digitakt and Analog Heat, in single or multiple configurations. Vertical multi-stand to come eventually. You can print these in - single-device configuration with "slim" side plates (5mm); this is not really recommended because it is slightly less robust, but might be preferrable if you're really low on space or prefer the slimmer aesthetic, - single-device configuration with regular side plates (8mm), or - multi-device configuration with regular side plates and middle plates. E.g. for an Analog Heat and a Digitakt, you need two regular side plates and one middle plate. For that plus a Digitone, add another middle plate. For each device, you also need three struts. Print left and right side parts and struts, stick and glue together. Ideally put some anti-slip feet on the bottom, and go make some music!