Stand for Tello drone 3D print model

cgtrader

Hi guys, this is my second project with Fusion 360 and I thought I would make a stand for my Tello drone. It works very well and shows up the beautiful Tello quite nicely. I could have made the drone angled support a little wider but I tried and the design does not look as nice when it is wider IMO. I used the following parameters for the print on my Ender 3 using Cura 4.0: Resolution: 0.2 Infill: 20% Wall thickness: 1.2 Support is needed (very minimal). Since the support is very small, make sure to use towers and increase the size a little to make sure you have good adhesion on the print bed. I hope you enjoy!