Stanley Blade Remix for Letter Opener

thingiverse

Loved the idea of a utility blade being inside the opener but only had the standard stanley blade. Redesigned it to take a more standard blade(see pictures.) Also added magnets cause why not? Use Modify g-code in Cura to pause at layer 6 to add the blade. It is a TIGHT fit. Put glue stick or hairspray on the blade so your filament sticks to it. I added the magnets after the print was done but it might be possible to add them during the print. They are also a tight fit. The magnets are 6mmX1.5mm round. I used PETG but PLA should work just as well. It might be a good idea to add supports to the magnet holes and the tip of the ramp leading to the blade. Just be sure to set supports to "Touching Buildplate" instead of "Everywhere" so it doesn't fill the area where the blade goes. It will probably be fine without supports too though.