Star Trek TOS - Desk Intercom - Rear enclosure modified to fit an Amazon Echo Dot 2

thingiverse

All I've done here is cut a round hole in the back of the enclosure to allow the insertion of an Amazon Alexa Echo Dot 2 smart home device. Note that it does stick out the back, and the bottom. The installation of mine puts the rear out of sight, and I've recessed the Echo Dot 2 into the bench top so that the whole thing sits flush on the bench top. I suggest following the instructions found here for the original project (https://www.thingiverse.com/thing:3314767) Note: I successfully printed this case in ABS without supports, standing upright. I used a brim for platform adhesion.