Star Wars themed light up Pencil Holder

thingiverse

Here is a pencil holder that is star wars themed. It has the star wars logo on one side, the Jedi logo, the sith logo, and the rebels logo. There are little holes on the lower rim of each face which can house 2 LEDs per face. There is also an electronics housing which attaches to the bottom of the pencil holder. The led holes lead to the little slots on the electronics housing so that you can run wires and the electronics housing can hold your wires and resistors and batteries. Comment down below if u have any questions or concerns. Post-Printing Assembly You can print the whole thing at once pre assembled, it should be one of the stl files attached. This wont let you put in LED's but u dont have to assemble it. You can print the 4 faces pre attached and have the base plate and electronics board separately so that you can remove them to wire LEDs, or you can print each part and assemble the whole thing. To assemble attach all 4 faces together first. Then create your LED circuit. I will post a schematic or picture of my circuit soon so you can see if you dont know how to do that yourself. I suggest wiring the LED's in parallel and have a resistor in series. Also put the LED's with connecting wires down the holes in the faces first, then wire up the batteries and resistors. Finally attach the electronics housing on the bottom by inserting the pegs in the holes. And then take the base plate and put it in from the top of the pencil holder (dont glue the base plate down. Comment if u have questions and i will post a video soon on how to do it so that it is more clearer.