Star Wars Tie Pilot Cosplay Chest Box Parts

thingiverse

Edit 3-13-19: I'm currently working on a revised Version box :) My friend is working on a Star Wars Tie Fighter Pilot costume cosplay but he mis-measured some cuts on his chest box and he then needed a fast replacement for an event. I made this thing with dimensions roughly derived from his Walt's Trooper Factory WTF chest box plus some dimensions I fudged from various build threads and resources online for parts I didn't have on-hand to measure. That being said, it isn't 100% accurate but it will probably get you by for 501st approval if that is your goal. ANH: https://databank.501st.com/databank/Costuming:TI_TIE_Pilot_ANH ROTJ: https://databank.501st.com/databank/Costuming:TI_TIE_Pilot_RotJ Print both halves and glue together. Use the 2mm holes in the lower donuts and bottom box half to align together for gluing (use a small Allen key or chunk of filament or a small screw). I have left an access hole in the back for ease of adding electronics as well as four 1/4" holes for mounting to your chest armor via bolts/wingnuts. I have included a template with the holes marked for tracing onto your chest armor to cut matching holes for mounting the chest box to (for I am a Generous God). There should still be plenty of meat for Velcro or magnets still if you would prefer either of those instead. Parts in this Thing: -1" by 1" by 1/8" square buttons (print 4) -18mm by 5mm round light (print 2, will fit into 1mm pockets in top box half) -Top box half -Bottom box half -Tube donuts top and bottom -.125" square button border "decal" -.125" horizontal pinstripe "decal" -Dial with eccentric knob (knurled Remix version here: https://www.thingiverse.com/thing:3251628 ) Parts NOT in this Thing: -Rocker switches and cogs, Use These: https://www.thingiverse.com/thing:2649572 -Male 1/4 Jack -- glue on a the base of a metal male snap or use a real 1/4" jack