Starbound Matter Manipulator - With LEds and Alignment

thingiverse

I modified the model to add a few things: 1. Holes for alignment pins since the chopped model has no alignment registration inherently 2. Holes for LEDs 3. Internal voids to run wiring for LEDs 4. A removable top cover for an insert to hold a switch and a 18650 cell 5. Recesses for magnets to hold the cover on Amazon links for materials: Pins: https://www.amazon.com/gp/product/B07M63L11L Cell Holder: https://www.amazon.com/gp/product/B07CWKGZXW Magnets: https://www.amazon.com/gp/product/B07873ZCY4 Resistor: https://www.amazon.com/gp/product/B0185FJ6RY Switch: https://www.amazon.com/dp/B08276JLGN Links to useful items: Spot Filler: https://www.amazon.com/gp/product/B004BZOTQQ Great for filling in gaps and inconsistencies in prints Tamiya masking tape: https://www.amazon.com/gp/product/B00J3TLZQC Thin masking tape useful for getting close to fine details since its easier to manipulate 5 minute epoxy: https://www.amazon.com/gp/product/B01M7VD07W Good for rapidly assembling your parts and offers a very secure bond. A little goes a long way. Just apply, clamp and in 5-15 mins you can unclamp and move on. Sandpaper: https://www.amazon.com/gp/product/B07D8QLN1N This sandpaper pack has all the grits you are going to need before priming. Sandable Filler primer: https://www.amazon.com/Rust-Oleum-Automotive-260510-12-Ounce-Sandable/dp/B006ZLQ4HQ This stuff is great. Spray this on to prime and then sand it back using some high grit sandpaper and it leaves a super smooth surface to paint onto. Fills in small scratches and imperfections pretty well.