Steam Link Mount MPSM

thingiverse

Remixed this to fit on the Monoprice Select Mini bed which isn't quite large enough for the original. This was a pretty beefy mount to begin with, so i cut a few speed holes to save filament/time. I printed in PETG and it's plenty strong enough to mount this behind the TV now. Update: Added steam-link-mount-MPSM_VESA100.STL.stl I moved the screw hole a bit to put this back at 100mm spacing. Print Settings Printer: MP Select Mini Rafts: No Supports: Yes Resolution: 0.2625 Infill: 10% Notes: Not much infill needed, I printed using 4 walls, top and bottom layers. Support is needed for the overhang above the DC jack and the edges that grip the back of the link. On the MP Select mini, i used a single line of skirt, just to purge the extruder before the print. There's not much room on the print bed for a brim, so make sure you have good enough adhesion to prevent a part this large from warping upwards at the corners. I was OK using glass/PEI @ about 70 degrees bed temp.