Steam USB Dongle Holder Battery Cover

thingiverse

A remix of balloneta's and CLB1's designs. When I printed the battery cover on my printer I ran into several problems. After much tweaking and prototyping, I finally got a model which works perfectly on my printer. Here is what I changed: * Tongs at the top are slightly farther apart. (They were printing a bit too close to fit) * Added clips to dongle holder to keep it from falling out. (The dongle was too loose and kept falling out when putting it away or taking it out) Finally (and most importantly).. * Fixed the bottom hook. (The hook on the original is the wrong shape; as such, the cover will not properly snap into place. At best, it would be knocked loose during play; at worse, it got jammed and was hard to remove.) Note: The clips might be a bit tight, try pulling the dongle out from the USB end.