Steamdeck dock with a USB hub holder

prusaprinters

<p>A stand for the Steamdeck. I also added a holder for <a href="https://www.alza.cz/alzapower-usb-c-dock-station-7v1-cerny-d6592235.htm">AlzaPower USB-C Dock Station 7v1</a>, but if you download the Blender file, you can edit it to fit whatever hub you have very easily. Just make sure that all your ports are on one side!</p><p>I glued the whole thing to the table and it's amazing. The two little dots fit very nicely into the screw holes and everything stays in place very strongly. The hub is held so tightly that you can even pull out cables without holding it down.</p><p>The stand doesn't interfere with the screen or thermal performance at all, although I recommend using black filament. The stand is also wide enough so that you don't tip the Steamdeck every time you change the volume or power it on.</p><p>&nbsp;</p><p>I recommend a similar setup to everyone trying to use the Steamdeck with a KVM.<br>&nbsp;</p><p>&nbsp;</p><h3><strong>My print settings:</strong></h3><p><strong>Layer height: </strong>0.3mm works perfectly fine</p><p><strong>Material: </strong>PLA works fine <i>(PETG would probably string a lot.)</i></p><p><strong>Infill: </strong>15% gyroid works fine</p><p><strong>Supports: </strong>No</p><p>The entire print took almost 4 hours with these settings.</p><p>&nbsp;</p><p><br><br>Stand inspired by: <a href="https://www.prusaprinters.org/cs/prints/135243-stand-for-valve-steam-deck">https://www.prusaprinters.org/cs/prints/135243-stand-for-valve-steam-deck</a></p>