Stella / Vepsa P Switch Cover

thingiverse

Simple switch cover blank for customization of the horn and headlight switches on a Vespa P or Stella. (I was lazy and this was a first go to see how it looked, so I didn't sand before panting) Note: the screw hole may have to be drilled out a bit to accommodate your screw; my MakerBot printed it a little tight. Note: The screw hole is off center. On the Stella, and I assume the same for the P, side smallest distance between the hole and it's edge goes towards the center of the headset. So you may have to flip the part depending on if this is going on the throttle or clutch side. Instructions This isn't so much "how" I made this, but "why": I had wanted to move my horn and turn signal switches to the throttle side (the white part (since painted) in the picture), so that the horn was always in a static position and the wires weren't being twisted every time you shifted. I built this blank to customize with the new switch and button I ordered off Ebay. I did not include the edits for these since yours will most likely vary. I also used another blank for the clutch side, just to cover up the space.