Stingy Clone (Puda 240) Tricopter Mod

thingiverse

Custom Parts for my stingy clone to tricopter conversion. 3 parts are included: 1) the tail plate: this plate holds the tail arm inline and sandwiches between the two bottom plates where the two rear arms normally would. Some very slight modification was needed, but I likely won't edit it unless I need a replacement or someone specifically asks. 2) Arm Protectors: These are simple remixes of https://www.thingiverse.com/thing:2916510 to allow for M2 screws on the motors I used rather than the normal M3 screws. 3) Tilt Mechanism: This is another remix, in this case of https://www.thingiverse.com/thing:889866. My version screws to the arm at the motor mounts, then gets held with the servo zip ties at the front. I included the 1808 motor version (M2 screws) and the standard (M3) version