Stone Mask from Jojo's Bizarre Adventure - Split & Fixed

thingiverse

First remix. I originally used Meshmixer to split the mask into 3 segments (top, middle, bottom). The top segment ended up a little too tall for my setup so I split it again (top 1 & top 2). I also used used Meshmixer a fix few holes that prevented the original from loading into Cura. The model is quite large, so it will need to be scaled down. I printed at 55% and the final product was still pretty big. It would probably be better at 45-50% or even lower. You will need 5 pegs between each segment to join them together. Scale the pegs the same as the mask segments. I recommend orienting the segments such that the conjoining surfaces (the surfaces with the peg holes) are not facing the plate, but perpendicular. I had some warping on the side with the build plate which caused gaps between the segments. Used a heat-gun to try to fix it as much as possible. This might be difficult for the middle section though. You will need supports for the middle section regardless due to the eye holes.