Stratux ADSB Case

prusaprinters

<p>Compact case for Stratux ADSB Receiver.</p> <h3>Print instructions</h3><p>Decided to make a compact case for Stratux receiver. BOM :</p> <p>1)Smraza Cooling Fan for Raspberry Pi 3 with 3 Pcs Heatsinks DC 5V for Raspberry Pi 2 Pi 3 Model B, Raspberry Pi 3 B+<br/> 2)uxcell® Power Supply DC 3.7V 8000mAh 7565121 Li-ion Rechargeable Lithium Polymer Li-Po Battery<br/> 3)Adafruit PowerBoost 1000 Charger - Rechargeable 5V Lipo USB Boost @ 1A - 1000C [ADA2465]</p> <p>Wiring for battery Charger -<br/> <a href="https://github.com/NeonHorizon/lipopi">https://github.com/NeonHorizon/lipopi</a></p> <p>I also soldered the thinner black and white wires with the white connectors to the back of the ahrs ( so the pi can shut itself down on low battery) re the wiring for adafruit post.</p> <p>The GPS un-solder the USB female socked and either buy or cut up a USB cable and solder directly onto the GPS board (gps wiring) photo<br/> Wiring i - shows the fan mounted the red and black soldered onto the back of the AHRS and the GPS in place ( I provided 1 screw to hold the GPS (I didn't leave a hole in the case, so you just have to push down and the screw will bite), use a plastic washer between the screw and the gps any plastic wrapping as long as it's thick as the screw can short out the LED near the screw hole</p> <p>The antennae - remove the black top covering so they look like in the pics. The longest antenna goes on the bottom - don't tighten the antennae base all the way in as you will struggle to fit the antenna, once the antenna base is half way in tighten the antenna base all the way (the retaining nut). For the top antenna, tighten the base all the way as there is space for theantenna to fit. Once they are tight insert the top antenna through the hole in the antenna compartment cover and then screw the cover in place.</p>