Stress Relief Spinner

thingiverse

This is a capped, no glue required, EDC/stress relief spinner. This model is designed to be assembled, with no bearing wobble, without any glue or spacers. Like most EDC fidget spinners, this model is designed to use four 22mm bearings. Print Settings Printer: HICTOP Aluminium Frame 3d Printer Rafts: Doesn't Matter Supports: No Resolution: 0.2 Infill: 100 Notes: Infill does not really matter, but a higher infill makes the product heavier. Post-Printing Preparing Bearings Outer 22mm bearings can be simply pressed into place to get a tight fit. The middle bearing, in order to get faster spinning, must be soaked in acetone for a few hours. Then, add high speed lubricant or WD-40 to the balls.