Studio Display Stand - Inspired by the Apple II

prusaprinters

<p>Recently picked up a Studio Display and wanted to add some height to to get it at eye level. I was looking at some of Apple’s previous products and found the Disk ][ and some photos of the monitor stand made for the Apple II, part number <strong>815-0540 REV. A. </strong>Pulling from this as inspiration I designed this stand to support my Studio Display.<strong> **</strong>This will only work with the &nbsp;version of the Studio Display with tilt-adjustable stand.</p><p>I would highly recommend utilizing the recesses made for some 10mm non slip feet. I used EVA foam but will use silicone if I replace the foam as it compressed completely under the weight of the display.&nbsp;</p><p>Notes on printing:</p><p>This is not an easy print. It requires a good deal of print time and plastic. There is also a significant amount of support material needed so I recommend only printing if you have a means to recycle your waste plastic.&nbsp;</p><p>I used PLA your mileage may vary with other materials.&nbsp;</p><p>The included 3mf file contains the recommended print orientation, supports, and settings that I recommend.</p><p>If you do not use the 3mf, I recommend changing the number of vertical perimeters to 3 for added strength and 15 or 20% infill should be plenty.&nbsp;</p>