Sugar Bowl With Lid

thingiverse

This is a pretty simple canister intended to hold sugar. The openscad files are here to allow you to adjust the model. Print Settings Rafts: Doesn't Matter Supports: Doesn't Matter Notes: I recommend 10% fill or more for both pieces. The lid requires support. The bowl does not. The bowl is about 70 mm in diameter at the top. With the lid in place, it is about 80 mm high. Scale both pieces the same to make them larger. Filament consumption is about 18 meters for the pair. Post-Printing The bottom of the bowl may benefit from a little acetone to help cement the filament together. The lid will need to be scraped in order to remove the support material. I recommend going around the lip-edge with a razor to smooth it out, so it fits snuggly onto the bowl-lip. As with all prints intended to touch food, several coats of polyurathane should be applied to help bacteria wash off in the dishwasher.