Sundvik Book Holder

prusaprinters

<p>This is book holder design to clip on the side of the IKEA Sundvik crib. &nbsp;I made two version. &nbsp;A plain one (easier to print) and a honeycomb version. &nbsp;The honeycomb is 25% lighter than the plain version, it's easier to see the book in the holder but the downside is the angle of the honeycomb is at 60°. &nbsp;It's printable but the surface finish is only okay.</p><p>I highly recommend PETG. &nbsp;I'm pretty certain that PLA will snap in two part when clipping (I haven't tried it).</p><p>Print with the “S” laying on the bed, no support required. &nbsp;I used brim for both to prevent lifting. &nbsp; Rectilinear infill @ 15% for better strength.</p><p>&nbsp;</p><p>To be safely used near a crib and child under 3, print without scaling, use non-toxic material and remove any sharp edges. &nbsp;Also, the hexagon are 15.4mm minimum opening. &nbsp;This meet JPMA opening size to prevent finger entrapment.</p>