Sunlu S1 - Upward Filament Guide and Humidity Sensor

thingiverse

This is a remix of TC's remix, "Sunlu S1 - Filament Guide+Temp/Humidity Holder", from printables. I rotated the outlet 180 degrees to get an upward angle. Then did a little additional editing to clear the lid.The original design which screws into the existing mount points is an excellent idea and solves two problems at once. It doesn't put too much strain on the filament guide and it strongly supports the humidity sensor.I have the drybox situated below my extruder so the downward slope of the original (and most similar models) is a problem. I remixed the model so that the filament exits the drybox at an upward angle.I printed this upright in a resin printer with minimal supports and it came out great. Yes it did warp a bit which could be fixed but it didn't interfere with the functionality so I didn't bother.I used resin so I didn't have to worry about the heat from mounting it on the metal heat shield of the drybox. If using fdm, be sure to consider this when selecting your filament.