SUNLU S8 Z-Endstop (No Extra Hardware Required)

thingiverse

I had a hard time leveling my SUNLU S8 until I figured out the factory endstop was probably at fault. This started as a remix of new_1's endstop, which was inspired by the one on my Ender 3 that I thought would be less likely to get caught on something. It prints fast and installs using only hardware from the original endstop. The slot is designed for flexible installation and alignment. The screws fit tightly in the slit and will strip if you're not careful. Attach the mount to the upright first, then carefully line up the endstop where you want it to touch before starting the screws to hold it in place. Finally, slide the entire assembly up/down until you reach a spot that works for your printer and firmly tighten the single mounting bolt. Don't forget to re-level your bed or adjust the z-distance if you're already leveled/trimmed.