Support for Hall sensor Y-endstop.

thingiverse

At first, I held my endstop in place with duct-tape to secure it firmly. A supporting rod was added to the back, greatly reducing its vulnerability. Unfortunately, no mounting hole exists in the design, requiring a carefully positioned drill. To access the Hall sensor situated below the pull-up resistor can be somewhat challenging due to its small size against a black background in the image provided. Printing instructions The nozzle's size is 0.4mm with layers also set at 0.4mm and an infill percentage of fifty. Optimal results are achieved by laying it flat instead of printing upright, which might cause imperfections.