Support Material Idea(Skeinforge Plugin Needed)

thingiverse

What do you do if you have a crazy large overhang and you can't just flip the model over? Try this. Bad Table is impossible to print on a makerbot without flipping it over and printing upside down. Good table though can be. You then just break off the single line think support material and you have your table. Instructions This is not ment to actually be printed. It is to show a concept I have used to print some crazy over hangs. If you have a circle or other overhang you need to make a ring around it slightly outside the hole diameter. this way the traces above can be made properly.