Swiffer WetJet handle

thingiverse

Designed a replacement handle for a Swiffer WetJet. I couldn't re-use the old switch and other handles on here were either very large or overly complex. My Simple Metal only prints 5.9", so I designed one that is less intricate and prints easily. I found that the bolts that run through the aluminum shaft put too much stress on the handle, so I just epoxied the handle to the shaft. Also used epoxy to secure the cap into the handle. Admittedly heated up the cap with a hairdryer just to get it soft enough to 'press fit' into the handle along with securing it with epoxy. I dropped the SLDPRT files in here if you want to grab them to modify the hole that the switch goes into. I just used a switch I had lying around I pulled out of an old toy or something a while back.