Swim Goggles Nose Bridge (Speedo Vanquisher type)

thingiverse

Swim goggles nose bridge, with some nicer geometry than the boxy square looking one I found here: https://www.thingiverse.com/thing:3837912 . These are not ones that are like a "strip" for basic recreational goggles -- there are already a few of those on the site that are perfectly serviceable (e.g., https://www.thingiverse.com/thing:946637). I printed these in PLA and with the curvature and material reductions, they are about 2/10 on a scale of flexibility. If you can print with TPU you may get better results, otherwise I recommend to go into the file and modify the various width parameters so that you get just the right size for your face. .SCAD file uses color coded shapes so you can see what each subtraction is controled by. If there is sufficient interest, I will consider cleaning up the code a bit and adding a parametric scaling factor to allow easier resizing. My guess is about 1 person will print this per year, as most "expensive" goggles come with spare bridge pieces, and by the time those are gone, the goggles have reached end of life from scratched unless you were very careful with them. Anyway, I printed this with supports in horizontal position, using "fine" setting for layer height and a .5mm gap from top of support to bottom of model. Pretty happy with the result.