Switch holder panel - Jeep Cherokee 97-01 XJ ash tray replacement

thingiverse

The ash tray top is curved, but only slightly. To save material and speed up printing this is printed flat and will curve to the console when screwed down. This is designed for a "standard size rocker switch for automotive use" hole size: a 22mm x 37mm square. The switch hole is slightly larger to allow for creepage during printing and variation from switch manufacturers. The screws go into the console under the area covered by the ash tray, so this can be removed and the ash tray replaced with no holes showing. Updated with a dual switch holder as well! The dual has a flatter face to allow for more uniform "bending" when being attached to the console and to make a much smaller stl file. Switch cut-outs on the dual are slightly tighter to keep the switches aligned a little better once installed. The exact switches used are ["Flip" switches](https://www.starcycle.com/?main_page=index&manufacturers_id=317).