Switch Knob Part 1 of 2 for Floor Lamp - Outer Cap

thingiverse

This floor lamp design includes a switch on its shaft, replacing an internal part that can break over time. The switch knob comprises two parts, both of which need to be printed with 1.5mm filament. After unscrewing the retaining nut, insert Part 2 into the plastic switch and replace the nut. Then, place Part 1 onto Part 2 for a tight fit. If necessary, sand or ream for better fitting, and use plumber's epoxy putty if there's still a gap after adjustments. Allow five-minute epoxy to dry overnight for a secure bond.