Swivel hinge and base for LCD holder

thingiverse

UPDATE, Added two additional variations to the printer-mounted part that shifts the display a little further to the left. This accommodates my wide spool holder, which was previously fouling the display. Still tweaking this design, need a few adjustments to get it just right, but the idea holds potential. The modification utilizes an LCD holder from Gadgets3D's LCD mount for Prusa i3. The LCD holder is modified by adding a single-piece hinge assembly and a keyway into the base part, allowing the display to tilt up and down, and rotate for easier viewing at different angles. Known issues persist: Pin diameter slightly undersized, nut recesses on the base too small, and base holes insufficiently sized. If enough interest materializes, I will update the design and post revised files. Update 1/18/2005 This revised version should assemble more smoothly. Instructions Printed at 30% infill, this design eliminates the need for support material if printed in supplied axis (assuming you print on a PRUSA I3).