Sword Wall Hangers

prusaprinters

<p>This is a customizable wall mount hook set for displaying swords... or whatever you want to hang from hooks, I guess :) The way this is designed, the hook slides up behind the back plate. A screw is used to anchor both of these to the wall through the mounting hole. This is designed to accommodate #6 screw anchors. Then to cover the screw, a face plate is slid down over the back plate.</p> <p>So far, I have only made two face plates - one with my signature hot pepper design, and the other with a calligraphic letter 'T', for Tombrello. I have included a blank plate for you to make your own design. If there is enough interest, I might be willing to do all of the letters of the alphabet myself.</p> <p>There are two hooks. The smaller hook works well for swords with little to no protrusion of the hilt. My particular swords have a rather large diameter hilt, so I had to move them away from the wall a bit.</p> <p>Pay no attention to the unfinished wall in the photos. That was the previous occupants "handiwork." I'll get around to repairing that later.</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Tevo Tarantula</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.2mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div> </p></p> Category: Decor