T-Nut M3 V-Slot Adapter for 6mm hex nut

thingiverse

I ran out of T-nuts and thought of creating one as an adapter. I found a similar 6mm here but the measurements are too tight and won't fit in, so I decided to create one from scratch. I made the geometry as simple as possible and made sure it fits with the actual 6mm nuts I have in store. Tested and fits snugly in place, as well as on the V-Slot, not too tight nor loose. Should fit CR-10, Ender 3, Ender 5, Kingroon KP3S or any printers with similar V-slot aluminum bars. Recommended PETG or ABS for better durability as PLA would easily crack. Lower down the Print Temp by adjusting fan speed to 20 or 30 percent, Travel Speed at 20 mm/s, Print Speed around 10 mm/s, 7 mm/s at Infill Speed, Wall Speed at 5 mm/s, and Retraction Enabled to minimize if not completely eliminate stringing.