T-Slot Fluid Holding Cup

thingiverse

Two T-Slot fluid cups are shown one in Yellow and one in Red. I had a metal can and it kept sliding around or off the mill so this is what I now use. Made the rectangular bottom part separate and super glued it to the flat bottom to avoid printing supports, etc. making it an easier build. I used a high % of infill to reduce fluid leaking through. I think mine was in the 80% area, but after a few months there still is a little coming through. Not enough to worry about, but if I made one again I would go to 100% fill and/or seal the inside with some varnish or something. Files; The Yellow has 2 components; Yellow Oil Cut and Base Red Yellow The Red has 3 components; Mill Cup Red, Brush Cap Red and Base Red Yellow