T800 Terminator Exoskull w/ 5mm LED Eyes with new base

thingiverse

Wonderful model.. Geoffro https://www.thingiverse.com/thing:290357 and machina! https://www.thingiverse.com/thing:438789 Thanks to irond4n for adding the LED changes! Why? First time I tried printing this, 2 of the vertical actuators came off the bed. I added the base so they have a good anchor. I also removed the supports. The only issue I had was with the left side of the jaw when it was at its most lowest angle. It worked out in the end but I would add a custom tree support just to that area if I printed this again. Printing with a layer step of 0.2 will probably fail with these supports removed. I removed them because they would of left horrible marks on the base where they are attached. I am including the non-supported Skull, The Skull with the base and the base alone in case you want to use the base with a supported skull. I also included the original base that has been sliced from the original model. Also included is the text sliced from the original base so it can be printed in a different color and glued to the base. The new base will fit on the original base and how I will mount this in its final form after the LEDS are installed. Cura Settings.... I used a wall count of 4 0.16 layer height Top thickness of 4 layers Bottom thickness of 3 layers Infill of 10% Zig Zag pattern Temp of 195 Bed temp of 60 Print speed of 30.0 Infill speed of 60.0 Inner wall speed of 45.0 Outer wall speed of 45.0 Initial layer speed of 35.0 and initial temp of 210 YOUSU gold silk This stuff is pretty but I am having stringing issues.