Tablet Holder (7" Android, iPad, etc)

thingiverse

A Tablet Holder (for 7" tablets) [10/10/18] Added for LGv410/Similar Tablets [11/27/16 - Renamed files, Tweaked designs, Added 'Lite' version for 7" Nexus] Versions: Astro --> Tablet's similar to "Astro Tab A735" Nexus --> Tablet's similar to "Asus 7" (Nexus 2012 version). Side relief for Button access. Kyocera --> Tablet's similar to Kyocera (this is a low profile, more compact tablet holder without added stuff). Tablet dimensions vary - Adjust for your Tablet's width and thickness by scaling the part. Use the Xsection for getting the correct scaling (no need to print the entire part until scale is dialed in). Options: Generic Base and Front inserts (Base can be used for storing Ear Buds, USB cable...). Bottoms - glue them on (they make it more comfortable to grip/hold). Nexus Tiltback: A stand for the Nexus in horizontal (& landscape orientation if using the Front attachment). Print Settings Rafts: No Resolution: See below... Infill: I used: 3 Top and 3 Bottom layers, 2 Shells, 20% infill.20% or more for all parts except Bottom (15%). Notes: Depending on your printer/software/skills, you may/may-not need supports for the overhangs. Use supports for the small horizontal overhang-lip that traps the tablet. May need them for overhangs so, test first... Clean-up / sand / file the bottom (brim) edges to ensure the attachments fit. Stylus Cavity: Clean it out if needed - I pre-clean with 23/64" drill-bit, and finish with 3/8" drill-bit. I printed several in PLA at 232 C to ensure bonding of Filament in the overhangs thus avoiding drooping threads. Print Height (z) = 0.2mm for tablet holder/other. Print Height (z) = 0.1 to 0.15 for the Bottoms (to prevent drooping threads).