Tablet Stand with push button adjustments

thingiverse

This is a tablet/phone stand that can be adjusted by pushing the button on the side. All parts are completely 3d printable parts including the spring and locking mechanism. It will even print on many smaller printers. (150mm) I have printed it on my Mono Price Select Mini and my CR-10S and they both came out great. The only part that needs any support while printing is the front leg and it will need full support for the hinge area. The rest of the parts print fine for me with no support. I would print the front and back on their thin sides, (see the combined plate for the recommended position) I hope you enjoy it. I included a combined plate but I normally print the parts separately because the front leg is the only one that needs support and removing supports from the spring would be a pain. It is a good size for a tablet (even my 10 inch tablet) but if you want it for a phone you can scale it down to 75% which is about a perfect size for a phone. I included a picture that shows the difference between full sizes and 75% and even one 50%. (I was still designing when I printed those smaller ones, so please ignore how the buttons on them are way too long) How to assemble: I included a picture that shows the direction each part goes in the legs hinge. Place both legs together, then push in the Gear, next push in the Spring, next push in the Spring Cap and the last step is the small pin to hold them in place. You will need to turn the spring cap so the hole lines up with the hole in the front leg hinge so the cap pin can go in. The diamond pattern cutouts were only to reduce the amount of plastic and print time while still avoiding supports. Feel free to make them solid or create your own design. I only ask that you do not sell them without my permission first.