Talon Claw sliding butt stock - Now Tool-less

thingiverse

This is now made to be tool-less using worker nerf stryfe battery door thumb screws. https://www.workerkit.com/p/Worker-Battery-Compartment-Hand-tightened-Screw-for-Nerf-N-Strike-Elite-Stryfe-Blaster-Black_2259878.html Please read. This uses McMaster 5/16 aluminum rods 89965K471, the same as used on the front of a Caliburn. I am cutting these to 180mm, which is also the same size you would use for the front of a Talon Claw :-) or use CF from amazon. I use through bolts so I can have a positive stop and not pull the slide out to far. But you don't have to. There is a PPT included if you need it. https://www.amazon.com/gp/product/B00TF8UW9C/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1 Use the kiri to butt spacer from this file set and not any other spacer. I drill a small hole in the sliding rod so the screw goes into the rod when extended. The force holding the SBS out should not be how tight you make the screw. Photo shows it.