Tamiya dancing rider / dual rider T3-01 brake

thingiverse

here is a fake brake disc and caliper set for the Tamiya T3-01 chassis, otherwise known as the dancing rider and Dual rider it makes the front wheel look alot more realistic especially after painting the caliper. the brake caliper just snaps into place on the hub, you could add a touch of CA but its not required. print the disc front face down ..unless you like removing support :) when fitting the disc make sure it bottoms out on the wheel hub, that will put it in the correct position. there are two versions of the caliper, one with a rear plate for if you are only printing the left side brake, it just looks more realistic but is abit more fiddly to fit and makes removing the support harder. (use minimal support) the backless caliper is if you are having a twin brake setup, it makes just clipping the calipers on alot easier! and you wont see the back of them so it doesnt matter :) for right side brake just mirror it in your slicer software. enjoy :)