Tank connector 1000L 3/4

cults3d

File Tank stopper 1000 L 3-4 This and a 1000 L tank connector with a 3/4 female fitting at the end. I tested it on one of my tank it goes very well. for the test of longevity we will see. the proposed version and identical on the photo except put the tube of thread longer for a printing without support. /////////////////////////////////////////////////////// Change from 1-6-2020 File Tank cap 1000 L 3-4 VR (VR for reinforced version) the front face increases from about 1.5 mm to 4 mm depressor which limits the risk of breakage due to pressure attention so that it is useful print with thickness of shell of 2 mm and top bottom same 2 mm After several attempts the PLA to break (bad pla or too tight) I redid the same file in PET no worries for the moment as for the plumbing sleeve, you have to force it to go in but it makes it watertight in any case with the PET for the joint I just fill with silicone and tighten by hand (not like a madman) your feedback is welcome.