Tau Printable RC Delta Wing- Lite Version

thingiverse

Designed to be much, much lighter than the original design, while still retaining the structural integrity. Use Monokote or packaging tape as a covering. Accepts all the same basic hardware (electronics and carbon tubes) but may require additional cutting on the rods to fit right. Parts have also been designed to be printed individually on a 150x150mm print bed. NOTE: I did not upload the ailerons under the files tab because they are identical to the original. Download the originals here: http://www.thingiverse.com/thing:901738/#files (they are called "Querruder" and there are two for each side). Print Settings Printer: Turnigy Fabrikator Rafts: Doesn't Matter Supports: Yes Infill: 25-75% Notes: Print infill may vary by part and filament used. This will also affect the CG of the plane so experimentation will probably be needed.