TBS Podracer complete build 4 and 5 inch

thingiverse

go easy, this took me a long time!! i crashed my podracer and the only way to get it back in the air was buy a whole new kit for the lower part that broke! so i decided to try and remake it, i then decided why not just make it all. As far as i can tell this is nearly perfect though it may need a little tweaking! im sure some of the holes in the mid plate may be a little off. I also included a slightly taller canopy as my wires didnt quite fit under the stock sized canopy that exists. print 100% infill, pla should be fine but asa or abs would be better. EDIT: Abull had edited the mid star shape which looks better than mine so check it out here: https://www.thingiverse.com/thing:5741587 the arms are usually pretty solid so if you have the carbon arms id use those unless you just want to print a whole quad then go wild! supports needed on the canopy only.