Technoblade Memorial Repaired for FDM

thingiverse

Fixed DJScope's version to make it printable on my FDM. Prints at 3 1/2 inches tall or higher. Supports must be used! My daughter is a huge fan of Technoblade and I fixed this so I could print it for her. I make my fixed verson available for the rest of his fans here. My Fixes (verified at 3 ½ inches or 8.9 cm tall): -Minimum thicknesses of parts set to 1mm. -Scaled to 3 ½ inches tall or 8.9 cm -Repaired mesh errors. -Reduced detail to make printable. My tested print settings (took 5hrs): -.2mm to .32mm variable layer height (the base at .32). -Painted on supports for 35-degree parts. -Printed at 3 ½ inches tall. -10% support cubic infill. -Perimeters set to 2. -Printed with Overture PLA. I recommend if you are not conformable using painted supports or variable layer heights, use .2mm and supports everywhere. I also recommend you set the support overhang threshold to 45-degrees because the back angle of the cape can be tricky if your adhesion is not great. Model made possible by art originally from @raxifire on Sketchfab: https://sketchfab.com/3d-models/technoblade-dreamsmp-fanart-35c6215307f8456abd596e29e2ef138c.