Tektronix 465 front cover

prusaprinters

<p>Hello, this is a front cover designed for the Tektronix 465 but probably fits the 465B (but not the M) or other Tektronix scopes. It fits well and won't fall off because of the clips holding it in place. Print it with at least 2-3 walls so the scope can rest on the cover if you wish to disassemble it.</p><p>Depending on your printer (settings) it takes around 16-18 hrs to print all parts and approx. 200g PLA. Still cheaper than buying an original second hand…</p><p>There are four files available. If you have a 200x200 mm (20x20 cm) print bed you have to print two parts and and glue them together. There are some 1 and 3 mm holes to glue rods in it for easy alignment and structural stability. For the 3mm holes use a threaded rod M3 and for the 1mm use a paperclip. The assembly is a bit complicated. Heat up the M3 rod a bit and jam it in the holes so it'll widen a bit, then glue it shut. The v2 has 3,2 mm holes to make it easier.</p><p>The holes are 100 mm deep. There are versions with the writing '465' and without available to print.</p><p>You have a print bed approximately or larger than 300x300 you're a lucky bastard. Just print the files with ‘whole’ in the filename so you don't have to glue anything.</p><p>Message me for requests if you need different dimensions or just the dimensions themselves. I'd be happy to help out.</p><p>This is a reupload from the version on Thingiverse, I'm the original creator.</p>