Tesla Charger Holder

cults3d

Update: 17-9-2022 Fixed export error in full Holder model. Deleted old model. New uncut model is Tesla_Charger_Holder_updated. Cable and charger holder designed to look like the Tesla Logo. There are 2 versions. One is sliced up to fit on an Ender 3 bed and one is full in case you have a bed big enough to print in one piece. The cover will work on both full and cut up versions. I printed this in PETG to be sure to withstand the higher temps of the garage in the summer. I also used a 0.8mm nozzle for final print but test prints were done with a 0.4mm so it will work with that as well. Assembly: After printing the 3 parts (top and bottom in red, and cover in white). Use your favorite plastic glue to glue top and bottom together. Do not snap on cover till installed on wall. Install: Screw in any drywall screw with anchor or other mounting that will fit in slide hole on back of holder. Slide holder onto screw and level. Mark screw holes and remove holder. Place drywall holders in at locations and replace the holder. Screw in flat screws to the two locations. Snap cover over screws.