Testors Aztek Airbrush to 1/4NPT Female Adapter

thingiverse

** Safety Note:  Air Brushes use pressure ~15-20psi.  Make sure you safely test your part prior to using them.  Start at your regulators lowest pressure setting and work your way up to the desired pressure while keeping a safe distance.  Even at this low pressure a failure could cause injury.  Making an adapter for compressed air that exceeds this is very risky as the part could explode and cause serious injury or death.  You have been warned.** Make sure you use 100% infill Some (all?) Testor Aztek Airbrushes are designed to work with the compressed cans of air. As far as I can tell the connector is non-standard. This file creates an adapter that allows a Testor Aztek Airbrush to be connected directly to a 1/4" NTP fitting so it can be used with a compressor. The OpenSCAD file requires The Maker Garage SCAD Library found here: https://github.com/themakergarage/tmg_scad_lib You can also check out the build log here: http://themakergarage.blogspot.com/2017/06/build-2-aztec-airbrush-adapter.html Good luck.