TFT 50 Mount for JGMaker Artist-D

prusaprinters

<p>I had a TFT35 v3 on my other printer and missed it on my Artist-D Pro. I started working on a different mount when I noticed Sebazzz generously included his source file.</p> <p>There are two mounts, The original was designed to mount to the power supply screws on the left side of the case. You'd need two M4 x 20 screws for this.</p> <p>The other mount is a magnetic mount. It also used the power supply screws, but only to locate. For magnets use two 8x3 mm magnets for each hole. I recommend doing the top and bottom holes and use the middle holes if you need them.</p> <p>You'll also need longer cables to connect your display and, unless you want to cut a hole in your case, you'll need to disassemble one end of the connector, thread it through a vent hole, then redo the connector end.</p> <p><strong>Note:</strong> Tested with my Pro. Let me know if the PS mounting screw is different for the base version.</p> <hr/> <p><strong>Update 7/24/2021:</strong> Moved the brace for the mounts to the top, to better hide the wiring.</p> <hr/> <p><strong>Links:</strong> 10 Pin Female to Female ribbon cable 5 Pin Female to Female ribbon Cable</p> <hr/> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>JGMaker Artist-D</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>Yes</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>200</p></div> <p><strong>Infill:</strong></p> <p>20</p> <p><strong>Filament:</strong></p> eSun PLA+ <p>Purple</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p><strong>Use 4 outer layers for strength</strong></p> Mount shouldn't need supports, but if you choose to print the touchscreen front open side down (like I did), maybe with ironing, which will take about a hour longer, you'll need supports. </div></p></p> Category: 3D Printer Accessories