The Avengers Hawkeye Folding Recurve Bow

myminifactory

I modeled this bow a while back shortly after The Avengers movie came out. Modeled in Blender.   If the pieces are too large for your printer, you'll have to cut the model into pieces or scale them all down the same percentage to fit.   I needed to drill a hole through the riser ends and each LimbInside piece to fit a bolt that holds the pieces in place.   Each hinge are tight fitting, so sanding will be necessary. I used a M4 threaded rod in the hinges for LimbOutside and LimbMiddle.   The HingeBolt and HingeCap were superglued into place. Total parts needed: 1 Riser 1 handle left 1 handle right 2 limb inside 2 limb middle 2 limb outside 4 hinge cap 4 hinge bolt